|Instruction(3G Programmable Flybarless System) :
||Specification(3G Programmable Flybarless System) :|
|●3-axis gyroscopic flybarless system to simulate the stability of mechanical flybar system, yet at the same time achieving agile 3D performance.
●Utilizes Silicon Micro Machine (SMM) sensors for excellent stability.
●12 bit processors providing ultra high resolution, resulting in highly precise controls
●Software upgradable through PC interface adapter
●Simplistic setup process without the need of external devices. Setup is done through 5 steps and 2 sensitivity adjustments. Rudder setup is identical to GP780 gyro, minimizing learning curve.
●Flybarless system dramatically improves 3D power output and efficiency, resulting in reduced fuel or electricity consumption.
●Highly sensitive gyroscopic sensors combined with advanced control detection routine providing higher hovering and aerobatic stability than other flybarless system.
●Suitable for all CCPM and mechanical mixing system.
●Comaptible with helicopter of all sizes from T-Rex 250 to T-Rex 700.
●Innovative Pitch Gau as an aid to facilitate pitch adjustments.
●High frame rate signal output for faster and higher precision servo response.
●Capable to operate between 3V to 8.4V, compatible with high voltage servos.
●Small footprint, light weight, minimalists and reliable design.
|●Suitable Voltage Range:DC 3~8.4V|
●Current Comsumption:<80mA @ 4.8V>
●Flip and Roll rate detection speed: :±300degrees/sec
●Rudder rate detection speed:±500degrees/sec
●Sensor resolution: 12bit
|Instructions(T-REX 500ESP):||Specification(T-REX 500ESP):|
【CF Frame Combo Version】
●Main Blade Length:425mm
●Main Rotor Diameter:970mm
●Tail Rotor Diameter:200mm
●Motor Ponion Gear:13T
●Main Drive Gear:162T
●Autorotation Tail Drive Gear:145T
●Tail Drive Gear:31T
●Drive Gear Ratio:1:12.46:4.68
●Weight(w/o power system):910g
●Flying Weight:Approx 1700g
●Outer carton:58x50x42cm ,12sets/ctn
|●T-REX 500 ESP 3G Kit Set X1 set|
●425D carbon fiber blades X1
●RCE-BL60G 60A Brushless ESC X1
(Built-in 5-6V step-less adjustable BEC)
●500M Brushless motor X1
●Motor ponion gear 13T X1
●DS510 M Digital Servo X3
●DS520 Digital Servo X1
●3G Programmable Flybarless System X1
Radio transmitter and electronic equipment required for assembly:
1.Transmitter(6-channel or more,helicopter system)
2.Receiver(6-channel or more)
4.22.2V 6S Li-Po 2100~2600mAh batteryX1
Find something wrong in this description?